土木工程施工课程设计(国外英文资料).docVIP

土木工程施工课程设计(国外英文资料) One, design topic Construction organization design of single layer industrial plant construction of rain and water machinery factory Second, raw data Project description: The new general assembly workshop of the rain and water machinery factory lies east of the factorys factory, south of the river bank, north of the village of shriver, and farmland in the southeast. The terrain is flat and the terrain is shown in the attached image. There is a permanent road to the north and west of the proposed workshop, and the water and power supply can be introduced directly from the nearby area for construction use. This workshop is for the single-tier two interindustrial plants, prefabricated reinforced concrete frame structure. Vertical: 16 x 6 = 96m, with 2 24m across. Two separate installation 20/5t bridge cranes, flat, profile picture 2 and attached figure 3. The plant is set up against the wind column. The main load-bearing components of the workshop are assembled reinforced concrete structures, other than foundation and pillar, and other standard components. In order to ensure the integrity of the roof and the rigidity of space, the sandalwood system is adopted. According to the specific conditions of the factory, which is less than 100 megabytes, the column is supported in the center of the workshop, and the end is equipped with an anti-wind column. The main load-bearing components of the factory are selected in table 1. The structure of the containment structure of the workshop is 24cm thick water wall and cement mortar. The cement mortar and mortar and the concrete slurry, the inner wall is sprayed white two way; The two link beams are prefabricated elements; The bottom of the column is the cast-in-place (FIG. 3), the foundation beam is the concrete foundation beam of the concrete. The roof of the house is made of two felted oil linoleum roofing. In the workshop, the concrete floor is now poured. Natural condition (1) the meteorological conditions: