土木工程毕业设计10 截面设计(国外英文资料).docVIP

土木工程毕业设计10 截面设计(国外英文资料) 218509 The second one 265.15 0.039 760 1211 420125 6 0.61 2 148.29 0.007 649 222760 3 226.83 0.024 760 1036 420125 6 0.61 4 150.2 0.009 628 686 320942 0.67 5 98.16 0.022 586 220628 a one 307.83 0.056 760 1405 422152 0 0.61 2 168.83 0.008 739 222760 3 237.75 0.028 760 1086 422152 0 0.61 4 169.2 0.009 760 773 320942 0.64 5 114.2 0.025 682 222760 0.81 The oblique section is calculated by bending capacity The capacity of the capacity of the bearing capacity was 0.85. In the case of the fifth layer AB and BC, the calculation method and procedure are given, and the reinforcement calculation of the other beams is presented. AB span beam The section size meets the requirement. 2 of beam end stirrup encryption district limb Φ 8 @ 100, stirrups with reinforced HPB235 level (fyv = 210 n/was), then: Stirrup encryption area length 1.2 m, 2 of the encryption section limbs Φ 8 @ 150 Settings meet the requirements. BC span beam The section size meets the requirement. 2 of beam end stirrup encryption district limb Φ 8 @ 100, stirrups with reinforced HPB235 level, are: Because the non-encryption area is small, all cross-over can be configured in an encrypted area. The calculation results and the results of the cross section of the beam are shown below. Cross section of beam cross section floor beam Gamma REV (kN) 0.2 beta cfcbh0 (kN) Asv/s Encryption area real match (Asv/s) Non-encrypted areas are matched Rho (%) five AB 92.69 656.37 0.22 Double limb Φ 8 @ 100 (1.01) Double limb Φ 8 @ 150 (0.224) The BC 40.04 484.77 0.42 Double limb Φ 8 @ 100 (1.01) Double limb Φ 8 @ 100 (0.337) four AB 171.84 656.37 0.17 Double limb Φ 8 @ 100 (1.01) Double limb Φ 8 @ 150 (0.224) The BC 79.08 484.77 0.15 Double limb Φ 8 @ 100 (1.01) Double limb Φ 8 @ 100 (0.337) three AB 190.28 656.37 0.26 Double limb Φ 8 @ 100 (1.01) Double limb Φ 8 @ 150 (0.224) The BC 113.97 484.77 0.08 Double limb Φ 8 @ 100 (1.01) Double limb Φ 8 @ 100 (0.337) The second AB 202.62 656.37 0.32 Double limb Φ