土木工程钢结构设计21m,总长90m梯形屋架(国外英文资料).docVIP

土木工程钢结构设计21m,总长90m梯形屋架(国外英文资料) Design of steel structure course design - 21m span steel roof design calculation 1 design data The total length of a workshop is 90m, the span L = 21m, the building system is not purlin system, the vertical column is 6m. Structural form: reinforced concrete column, trapezoidal steel roof frame. The concrete strength of the column is C30, and the slope of the roof is L / 10. L for roof span. The area calculated temperature above -200c, non-corrosive medium, not considering earthquake prevention, the lower chord of the roof is 18m. The bridge crane is 2 150/30t (intermediate working system), and the forging hammer is 2 5t. Roof form and load: roof form, geometry and internal force coefficient (the internal force of the nodal load P = 1.0) as shown in the attached diagram. The steel and electrode used in the frame are: Q345 steel, the electrode is E50. Roof structure and load No purlin system: 1.5 by 6.0 m prestressed concrete roof (considering the role of the housing bar) Load: The frame and the supporting weight: according to the empirical formula q = 0.12 + 0.011 L, the frame span of the frame, the unit of m, q is the roof and the supporting weight, the kN/m2 is the unit; (2) : the roof live load construction live load standard value of 0.7 kN/m2, snow load basic snow pressure values for S0 = 0.35 kN/m2, construction live load and snow load is not considered at the same time, but take the larger of the two values; The ash load is 0.6 kN/m2. The load standard value of each of the layers of the roof: Three felt oil (spread green bean sand) waterproof layer 0.4 kN/m2 The cement mortar is leveling off by 0.4 kN/m2 The insulation layer 0.7 kN/m2 A felt oil layer 0.05 kN/m2 Cement mortar for leveling layer 0.3 kN/m2 Prestressed concrete roof slab 1.45 kN/m2 Structure and arrangement The form and geometry of the frame are shown in figure 7.30. The roof support arrangement is shown in figure 7.31. Figure 7.30 frame form and geometry size 3 loa