投影机的使用指南(国外英文资料).docVIP

投影机的使用指南(国外英文资料) The use of the projector Q: what happens when the projector connects the laptop to the non-output image? A: when A laptop is plugged into A device, there are usually four display output controls. The laptop LCD is bright, the external display equipment is bright The laptop LCD is bright, the external display equipment is not bright The LCD screen is not bright, the external display equipment is bright The LCD screen is not bright, the external display device is not bright Solution: just press the laptop keyboard button to switch. TOSHIBA (Fn + F5) IBM (Fn + F7) Compaq (Fn + F4) Gateway (Fn + F3) (Fn + F3) Panasonic (Fn + F3) Fujitsu (Fn + F10) DEC (Fn + F4) Sharp (Fn + F5) (Fn + F8) Q: the output of the projector is unstable. What is the reason for the fluctuation? A: the projector power signal is not in common with the source of the signal source. Solution: plug the projector into the same power connection board as the signal source device. Q: when you buy, the projected effect is good and the results are bad. Why? A: A lot of times its not A machine problem. For example: input source signal noise ratio is not ideal; The screen quality is too poor to affect the projected image directly. Solution: pay attention to the source selection. Consult the buyer and select the screen that matches the purchase machine. Q: how should the shadow image be resolved? A: most of the time due to the poor performance of the connection cables. Solution: replace the signaling line (note the matching problem with the device interface) Q: how do you clean up the ventilation filters? A: in order to ensure the normal work of the projector, regular inspection and maintenance is essential. Clearing the ventilation filters is one of the important things. If the projector ventilation filter is blocked by dust, it will affect the ventilation inside the projector and cause the projector to overheat and damage the machine. At any time, make sure the ventilation filters are proper