机泵操作规程(国外英文资料).docVIP

机泵操作规程(国外英文资料) Operating procedure of machine pump The opening, stopping and switching operation of centrifugal pump Pump operation of centrifugal pump The initial state S0 Centrifugal pump air condition, isolation, machine, electricity and instrument system are ready Centrifugal pump preparation: 1.1 assist system: 1.1.1 [P] - the cooling water State of S1 The centrifugal pump is equipped with pump conditions 1.2 centrifugal pump irrigation pump 1.2.1 room temperature pump irrigation pump 1.2.2 high temperature pump priming pump 1.2.3 air pump irrigation pump State of S2 The centrifugal pump has the pump condition Centrifugal pump pumps 2.1 start motor State the S3 The centrifugal pump runs the pump Confirm and adjust after startup 3.1 pump 3.2 power equipment 3.3 process system 3.4 supplementary operation A final state FS Centrifugal pump is running normally operation The initial state S0 Centrifugal pump air state - isolation - mechanical and electrical systems are ready Scope of application -- pumps driven by electricity - room temperature pump - heat pump - liquefied gas pump instructions (P) - the pump is finished by the engine (P) - the pump is in a state of no process (P) - confirm that the coupling is installed (P) - make sure the shield is installed (P) - the pumps machine, electricity and equipment are confirmed (P) - the pump is smooth and flexible (P) - the pump entry filter is cleaned and installed (P) - confirm that the cooling water is drawn to the pump (P) - confirm the analysis of the lubricating oil test (P) - confirm the oil in the bearing box is normal (P) - confirm the valve closing of the pump (P) - confirm the valve closing on the pump heating line (P) - confirm the closing of the valve on the sealing line (P) - confirm the pumps drain valve opens (P) - confirm that the pumps motor switch is in or out of condition, and the interlock is removed (P) - confirm that the pumps motor is out of power Centrifugal pump preparation: [P] -close the pump