轨道静、动态几何尺寸容许偏差管理值(国外英文资料).docVIP

轨道静、动态几何尺寸容许偏差管理值(国外英文资料) The static geometry dimensions of the line track allow for deviation management values item Nu main Max 160 km/h 160 km/h nu or Max Main 120 km/h Nu Max 120 km/h or less The main line and the arrival line Other station, homework acceptance often maintenance temporary The repair homework acceptance often maintenance temporary The repair homework acceptance often maintenance temporary The repair homework acceptance often maintenance temporary The repair Gauge (mm) + 2 2 - + 4 2 - + 6 4 - + 4 2 - + 6 4 - + 8 4 - + 6 2 - + 7 4 - + 9 4 - + 6 2 - + 9 4 - + 10 4 - Level (mm) 3 5 8 4 6 8 4 6 10 5 8 11 Height (mm) 3 5 8 4 6 8 4 6 10 5 8 1 l Track (line) (mm) 3 4 7 4 6 8 4 6 10 5 8 11 The triangle pit (distorted) (mm) Easement curve 3 4 6 4 5 6 4 5 7 5 7 8 Straight lines and Circular curve 3 4 6 4 6 8 4 6 9 5 8 10 Note: the gauge of the gauge is set by the specified amount, but the maximum gauge (including the width and the deviation) should not exceed I 456mm. The maximum value of the vector that is measured in the direction of the deviation and the low and low deviation. (3) triangular hole deviation excluding curve of high slope distortion caused by the quantity, check the triangle pit base is 6.25 m long, but no more than the 18 m in extended range table column triangle pit; The special line is handled by other station line. The static geometric dimensions of the bifurcation track allow for the deviation management value item Nu Max 160 km/h 9 160 km/h nu or Max 120 km/h 9 Nu Max 120 km/h or less The main line and the arrival line Other station, homework acceptance often maintenance temporary The repair homework acceptance often maintenance temporary The repair homework acceptance often maintenance temporary The repair homework acceptance often maintenance temporary The repair Gauge (mm) + 2 2 - + 4 2 - + 5 2 - + 3 2 - + 4 2 - + 6 2 - + 3 2 - + 5 - 3 + 6 - 3 + 3 2 - + 5 - 3 + 6 - 3 Level (mm) 3 5 7 4 5 8 4 6 9 6 8 10 Height (mm) 3 5 7 4 5 8 4