屋顶大跨度下悬索钢梁施工(国外英文资料).doc

屋顶大跨度下悬索钢梁施工(国外英文资料) Construction of steel girder under the roof of the roof In jiangsu province su zhong construction group co., LTD. Gu mingchun Graduate school of Chinese academy of sciences of zhongguancun building engineering one of top ten excellent design work of Beijing in 2002, the project is located in the haidian district of Beijing zhongguancun south a no. 3. The project is made up of two buildings in the south and north, and the two buildings are between the two buildings. The east and west facades of the atrium are made of glass curtain wall and semi-hidden glass curtain wall, and the top is a reversible glass skylight. At the top of the east entrance of the building, there is a 144m2, 48-m suspension steel structure. All the loads in the canopy are passed to a lower suspended cable beam with a span of 29.034 m. In addition, the beam also bears half of the surface load of the glass skylight of 180m2 on the other side. The value of the load on the beam is calculated to be 15.662 KN/m, the maximum bending moment value of 1469KN m, and the basic air pressure value is 0.35 KN/m2. The beam is 22.10 m from the ground and the beam body weighs 84.6 KN. Design of girders The main beam is welded with Q235 steel plate, the cross section is H700 x 450 x 16 by 25, the upper and lower flaps are 25mm thick, the abdominal plate is 16mm thick, and the stiffening plate is 14mm thick. The stiffening plate is arranged along the length of the beam, the distance is 1.8 m, and the beam is properly encrypted. The bending moment of the girder is borne by the upper chord, and the string control of the lower string is controlled across the middle. The steel strand pretensioned the 55KN force to resist the bending moment 110KN m. After the calculation, the total disturbance of the girder was 148m, and the beam body precamber 83.7 mm to offset the self-disturbance, the actual disturbance was 64.3 m. The beam form is shown below: Construction of girder 1, factory preweld Because o