掉落蜡法周详锻造(国外英文资料).doc

失蜡法精密铸造(国外英文资料) Is able to keep a certain gap, and can be as often as possible will wax wax mold welding in the tree, that is, a wax tree to a on the highest number of wax pattern, already meet the needs of the mass production Fill the gypsum and vacuum Will wax tree on the chassis connected set of stainless steel tube (steel bell), single sided tape on package on the outside of the steel fluid (gummed paper finally should be higher than that of steel fluid along the 2 cm) standby choice high quality casting powder (jinxin 3 g card, for example) 1) gypsum slurry: by 38% to 40% of the water powder, pour the powder into the water, stirring for two to three minutes. The first vacuum (1 ~ 2 minutes) 2) note plaster: vacuum after the gypsum slurry slowly along the inner wall of steel fluid injection, avoid by all means the gypsum slurry directly in wax tree, until the gypsum slurry wax tree about 1 cm, immediately on the second vacuum vacuum 3-4 minutes to complete, natural placed 1 -- 2 hours to ensure the setting of gypsum Baking plaster Plaster mold baking is the most important working procedure to ensure normal casting in general, 18 k gold molding baking time for 6 ~ 12 hours, platinum molding baking time of 12 ~ 20 hours of baking function basically has: dewaxing, drying and casting heat preservation with 18 k gold baking, for example, dewaxing temperature of 0 ~ 350 ℃, holding time 2 hours. Drying temperature is 350 ~ 700 ℃, holding time 2 ~ 3 hours. Casting heat preservation temperature is 550 ~ 650 ℃, holding time 1 ~ 2 hours The normal baking process is to preheat the resistance furnace to the initial temperature, and then the cast water outlet to the furnace, so that the wax fluid evaporates. Area in initial temperature for 1 hour, then gradually at 1 ~ 2 hour intervals l/cooling speed and the constant temperature heating (or cooling) should be kept in 100 ~ 200 ℃ / hour, otherwise heat up too fast the crack of plaster mould, may result in serious damage of p