水泵震动的启事及处理方法(国外英文资料).docVIP

水泵震动的原因及处理方法(国外英文资料) Cause and treatment of pump vibration For the vibration of the parts of the pump unit, the cause of the vibration is analyzed. From the hydraulic and mechanical design of the pump, the measures to reduce the pump vibration are put forward in the installation, operation and maintenance of the pump. The results show that the size of the pump parts, the accuracy of the pump is suitable for the hydraulic characteristics of the pump. Ensure that the actual operating point of the pump is in line with the design point of the pump. To ensure the consistency of the accuracy of the machining and the accuracy of the design; To ensure the quality of parts and parts to be consistent with their running requirements; Ensure the consistency of the quality of repair and the wear and tear of the parts, which can reduce the vibration of the pump. Vibration is an important indicator of the operating reliability of pump units. The danger of excessive vibration is mainly: the vibration causes the pump unit to not function properly. Causing the vibration of the motor and pipe, causing the machine to injure the person; To cause damage to the bearings and other parts; Causing loose connection parts, foundation cracks or motor damage; To cause loose and damaged pipes or valves connected to the pump; To form vibration noise. There are many reasons for the pump vibration. The shaft of the pump is usually connected directly to the drive motor shaft, allowing the dynamic performance of the pump and the dynamic performance of the motor to interfere with each other. High speed rotating parts, move, static balance to meet the requirement; The parts affected by the flow are affected by the current situation; The complexity of fluid motion itself is also a factor limiting the dynamic performance of the pump. Analysis of cause of pump vibration 1.1 the motor The structure of the motor is loose, the bearing positioning device is loose, the iron core silicon steel is loose, the bea