浇注系统及脱模结构设计(国外英文资料).docVIP

浇注系统及脱模结构设计(国外英文资料) Project simulation network of guangzhou engineering simulation technology co., LTD Gating system 5.1 determines the position of the shape Had lateral concave because of the plastic handle, we use hough institutions to forming, the two sliding block arranged on both sides of the handle, each slide block forming the handle of a side concave. The choice of 5.2 points Choose the principle of parting: (1) it helps to remove the mold; (2) to ensure the quality and accuracy of the plastic parts; (3) to facilitate the processing and manufacturing of molding parts; (4) the number and shape of the fractal surface are usually parallel to the shape of the plane, which is the vertical plane with the direction of the motion of the injection machine. Cavity (5) the determination of orientation: to determine the location within the cavity in the mold, the parting surface selection should as far as possible to prevent the formation of side hole or concave side, in order to avoid the complex mould structure; (6) it is beneficial to the side pumping. (7) consider lateral extraction. (8) should be long direction core-pulling or parting distance under dynamic and decide on the direction of mold opening and closing of the die, and the short pull distance as lateral core or core-pulling, and pay attention to side core-pulling at the edge of dynamic model, avoid the fixed mold core pulling; (9) the requirement for locking the mould; (10) in favor of exhaust; The technical parameters of the injector should be considered in the selection of the fractal plane. Combined with the actual condition of this plastic, the fractal surface is shown in figure 5-1 Figure 5-1 In order to avoid the sharp Angle of the A and the slider, the parting should be on the bottom of the circle. The selection of the runner sleeve With handle cover due to use direct gate, the need to shape at the bottom of the decorative pattern, so credits set bottom must work out the required pattern, detailed