混凝土浇注方法(国外英文资料).docVIP

混凝土浇注方法(国外英文资料) Method of concrete pouring First, the concrete should be watered immediately, and the water should start from a corner or a place, gradually expanding to the surrounding area. The concrete should be layered and rammed, and the thickness of each layer shall be 200mm, no more than 1.25 times the part of the insertion vibrator. Two, the surface of the template is clean, the combination is rigorous, the support is strong, each dimension meets the requirement. 3, the water concrete should not be isolated, and the height exceeding 2M should fall in the pipe, inclined trough or string. Fourth, the concrete should be poured into a continuous, such as interrupt for pouring system is more than the initial setting time, then you must wait for the compressive strength of concrete reaches more than 12 kg/cm2, will play hair surface, wash with water, and then poured a congruent with the original concrete layer of mortar, continue pouring system. When watering, check the template and support for deformation, sinking, moving, or running pulp, such as finding that it should be dealt with immediately. Six, vibrator, the operation will make its natural inserted smoothly, to do fast plug slow pull principle, mainly to prevent segregation phenomenon and a vibrator with concrete under the pull out form when empty. The depth of the vibratory rod is usually 50 ~ 100mm into the lower concrete, and the point is inserted into the movement, evenly, not missing. Eight, vibrator not impact reinforcement and templates, vibrating time should be sufficient, good grasp of the vibrating time generally each interpolation point about 20 ~ 30 seconds, the shortest not less than 10 seconds, prevent leaking of vibration and vibration. No longer significant sink to concrete surfaces, and without a lot of bubbles radiant with advisable, should pay special attention to marginal parts of the vibrating, italics, vibrating, ensure the real outside light in the concrete. Nine, concrete vibrators