灌桩注意事项(国外英文资料).docVIP

灌桩注意事项(国外英文资料) Pile notice The reason of pipe plugging in the construction of bored pile concrete In concrete construction are often bored piles of catheter jam phenomenon (referred to as card), the reasons for this phenomenon are: 1. The tube flange leakage (permeable). The inside of the catheter is separated by a layer of water, where the inner concrete is not flowing and the catheter is blocked. The inside of the catheter is separated by air pack. Similarly, the inside of the catheter is not flowing and the catheter is blocked. Pipe cracks. The wall of the tube was too thin in the construction to be violent, causing the wall of the pipe to crack, and he caused a crack in the wall of the pipe. Cracks, hole water pressure is bigger, the water will tube concrete dilution, segregation, make concrete loss of liquidity and increase the friction of guide wall concrete, resulting in congestion. 4. Used in the concrete construction sand, stone and other raw materials distribution unqualified or water cement ratio is not correct and segregation of concrete, stone and sand deposit in catheter bottom, slurry floatation; In the construction, the requirement is not strict enough, and the actual requirement has a great deviation, and the precipitate segregation rate is accelerated. 5. Concrete pouring process of discrete and continuous time is too long, or adjust the infusion process time is too long, already pouring underwater concrete, also can appear catheter jam. At the beginning of the irrigation, the pipe was blocked by a water plug. All of these reasons can not be carried out normally in the construction of bored pile concrete. Secondly, according to the analysis, it is pointed out that reasonable avoidance and solution should be found Above has appeared in concrete construction of bored piles of catheter jam causes are analyzed, how to avoid and solve the catheter jam, should be sufficient attention in the actual construction and timely solve. Talk about how to avoid a