第二十一章、模板工程( 易达定额说明)(国外英文资料).docVIP

第二十一章、模板工程( 易达定额说明)(国外英文资料) One, the present concrete template is pressed by different components, with the plywood template, the wood template, the steel support and the wooden support system. When the height of the beam and plate is 3.6 m, the height of the set is 3.6 m. When the height above 3.6 m, more than part of each increment of lm is calculated. When the height of the set is 10 meters, the height of the set shall be 10m. When the height exceeds 10 meters, more than part of the module is calculated according to the corresponding increase of lm. When the mode height reaches 20m, a height of 20m is applied to the corresponding suborder. When the mode height exceeds 20m, more than one part is calculated according to the corresponding increase of lm. When the height exceeds 30 meters, the construction plan will be determined separately. When the height of the column and wall is 3.6 m, the corresponding children in the height 3.6 m are used. When the height above 3.6 m, more than part of each increment of lm is calculated. When the die height reaches 10 MB, the corresponding suborder of 10 MB is applied to the set. When the height exceeds 10 meters, more than part of the module is calculated according to the corresponding increase of lm. When the mode height reaches 20m, the corresponding suborder of a height of 20m is applied. When the mode height exceeds 20m, more than one part is calculated according to the corresponding increase of lm. When the height exceeds 30 meters, the construction plan will be determined separately. The height of the floor is the height of the floor. The pavilion panel is high above the eaves line. The floor of basement floor is more than 3.6 m and each additional 1m is calculated according to the number of works day, steel support and vehicle load times coefficient 1.20. The pool is calculated according to beam, board, column and wall. Vi. The different column and shear wall are divided in one direction: The height of the balcony and