联轴器联接误差(国外英文资料).docVIP

联轴器联接误差(国外英文资料) Coupling error of the coupling The radial displacement of the cross shaft coupling is less than or equal to 0.04 d, the diameter of the axis. Column elastic sleeve pin coupling, allowing the axial displacement of 2-7.5 ㎜, 0.2 0.7 ㎜ radial displacement, partial angular displacement 30 ° 30 - 1. Elastic dowel pin shaft coupling (nylon column pin) allow 0.1 0.25 ㎜ radial displacement. Coupling assembly A, flange coupling assembly, two and a half coupling between end face (including semicircle with circle) should be close contact, two axis should not be greater than 0.03 ㎜ radial displacement The assembly of the cross slider coupling and the coaxial coupling shall be in accordance with the provisions of table 1, and the end clearance shall be in accordance with the provisions of table 2. Table 1 coaxial degree (㎜) The maximum diameter of the coupling (D) The coaxial degree of the two axes The radial displacement tilt 300 or less 0.1 0.8/1000 300-300. 0.2 1.2/1000 Table 2 end clearance The maximum diameter of the coupling (D) End clearance The cross slider coupling Coiled claw coupling 190 or less 0.5 to 0.8 2 (+ 0.2) 190 1.0 to 1.5 2 (+ 0.2) The assembly of the snake-shaped flexible coupling, the coaxial and end sides of the coupling should meet the rules of table 3. Table 3 coaxial and end surface clearance The maximum diameter of the coupling (D) Two shaft alignment End clearance Radial clearance tilt D 200 or less 0.1 1.0/1000 1.0 to 1.5 200 D 400 or less 0.2 1.5 to 2.0 400 D 700 or less 0.3 1.5/1000 2.0 to 2.5 700 D 1350 or less 0.5 2.5 to 3.0 1350 D 2500 or less 0.7 2.0/1000 3.0 to 3.5 D 2500 1.0 3.5 to 4.0 The assembly of the gear coupling, the coaxial degree of the two shafts and the clearance of the outer teeth of the outer teeth, should be in accordance with the provisions of table 4. Table 4 The maximum diameter of the coupling (D) Two shaft alignment Outer teeth clearance Radial clearance tilt 170 D or less 220 0.30 0.5/1000 2.5 to 5.0