多热源联合热泵的性能模拟.pdf

第 50 卷 第 2 期 天津大学学报 (自然科学与工程技术版) Vol. 50 No. 2 2017 年 2 月 Journal of Tianjin University (Science and Technology) Feb. 2016 DOI:10.11784/tdxbz201507052 多热源联合热泵的性能模拟 杨 昭，马常胜，陈 贺 (天津大学机械工程学院，天津 300072) 摘 要 ：基于燃气内燃机热泵较高的烟气余热利用价值，提出 了一种利用内燃机烟气与太阳能联合驱动的氨水吸收 式热泵循环，建立了传统的燃气内燃机压缩式热泵与吸收式热泵的联合供能系统模型，并通过模拟计算分析了系统 性能系数的影响，并与传统燃气热泵的热力性能进行了对比．结果表明，该系统在不增加能耗的基础上，一次能源 利用率从原来的 1.49 提高到 1.98，输出热量从 86,kW 增加到 115,kW ，同时烟气余热回收率从 0.20 提高到 0.29． 关键词 ：燃气内燃机热泵；烟气余热利用；吸收式系统；一次能源利用 中图分类号：TK115 文献标志码 ：A 文章编号 ：0493-2137 (2017)02-0142-05 Performance Simulation of Combined Heat Pump Driven by Multi-Heat Sources Yang Zhao ，Ma Changsheng ，Chen He (School of Mechanical Engineering ，Tianjin University ，Tianjin 300072 ，China) Based on the comparatively high heat utilization of waste gas by gas engine-driven heat pump (GEHP) ，a Abstract ： new ammonia absorption heat pump cycle jointly driven by high temperature flue gas and solar energy was put for- ward ，and then a joint energy supply system model of traditional gas engine compression heat pump and absorption heat pump was established．By calculating the parameters of the system ，the impact of different operating tempera- tures on the coefficient of performance of the system was discussed ，and its thermal performance was compared with that of a conventional gas heat pump．The results show that without increasing the energy consumption ，the primary energy ratio (PER)can be improved from 1.49 to 1.98 ，heat output is