HD硬盘检测讲解(国外英文资料).docVIP

HD硬盘检测讲解(国外英文资料) To view the article HDtune detects the meaning (from the network, not entirely) 01-01-01-01-08 = Read Error Rate/(low-level) data Read Error Rate Refers to the hardware of occurred while reading data from the disk surface read error ratio of the Raw values for different manufacturers have different system, simple as a decimal number is meaningless. * above for English translation version on the Wiki, this property is apparent differences, some said high value for good, others said lower well, lets follow the Wiki here, anyway, so long as the Worst is not less than the Threshold. * * the Raw value here might be different, for example, the ST hard drive in my laptop is 0, while the 1.5-t ST on the desktop is 227901540. 02 = Throughput Performance/Throughput Performance (read and write flux Performance) Raw value, the higher the better Overall (common) hard drives throughput performance. If the value of this property has been falling, there is a big chance that the hard drive has a problem. * its not worth it until its been tested by an artificial Offline S.M.A.R.T. 03 = Spin Up Time/motor to rotate to standard speed The lower the Raw value, the better The average time of rotation of the main shaft (from zero RPM to full operation [milliseconds]). The units could be seconds. If its zero, youre going to prove that this term is not read right, or that this is a data generation error. You shouldnt have 0. 04 = Start/Stop Count/Start/Stop Count The count of the motor start/stop cycle.The count increases when the motor starts or the hard drive stops completely and the boot and hard drive return from the sleep mode to the previous state. * in general this is a startup, can also be seen as electricity, it is usually a reference value, life itself has no any indexes, when buying a hard disk can refer to this value. 05 = the Count of Count/rematch Sectors of Reallocated The lower the Raw value, the better To redistribute the sector count, when the hard disk an