场地断面土方计算(国外英文资料).docVIP

场地断面土方计算(国外英文资料) Step 1: show the elevation points within the compute area The second step: paint should be smooth closed boundary line (cutting line), to determine the direction and length of the profile line, the length of the line profile should be fellowship with closed boundary at the ends of the line Step 3: click on the project application, generate mileage files generated by profile line, new choose by tip profile line, pop-up generated by profile line mileage file dialog, option node, fill in the transverse spacing and the length of left and right (cross section length should be closed out of the border line, mainly considering slope problems), was determined Step 4: click the engineering application to generate the mileage file, which is added, lengthened and cut by the vertical section line. Lengthening is the problem of adjusting the length of the cross section. Shear is cut off the cross section of the slope. In the first step is completed, you can probably determine put the position of the slope, on the surface of the figure, closed line point chosen this closed after shear line, long out of the line transect will be deleted Step 5: click on the engineering application, generate mileage files generated by profile line design, according to the prompt to choose cutting boundary (flat closed boundary line), then prompted to select the cutting line, then the left line transect and cutting line intersection point design elevation to appear on the dialog box, enter the section of line design elevation, carriage returns, and choose a cross section line, and so on, after the input to exit Step 6: click on the engineering application to generate the mileage file from the profile line. The first column should choose the first exhibition point elevation data file (format: DAT), the second column should be input and save the generated mileage filename format: (HDM), the third column should be input and save the corresponding coordinate data file name (format: DAT