汽车地盘实训(国外英文资料).docVIP

汽车地盘实训(国外英文资料) The practical training program a car clutch to disassemble and study One, knowledge requirement The function, composition and principle of the clutch The type, phenomenon, and cause of the common fault of the clutch Focus on content: the function, composition and principle of the clutch; Basic construction of the clutch; The cause of the clutch failure Capacity requirements The correct removal and repair procedure of the clutch Fault diagnosis and maintenance of the clutch Second, the course of practice 4 class Third, actual training equipment Tools: a set of common tools and a vernier calipers. Equipment: a clutch assembly. Four, the actual training step Disassemble and install the clutch The disassembly of the clutch First remove the transmission. Use tools to fix the flywheel, then gradually will clutch pressure plate fixed bolt diagonal unscrew and remove the clutch cover and the pressure plate assembly, and remove the clutch platen. The clutch parts are then decomposed. The installation of the clutch Fixed the flywheel with tools. Use the tool to locate the clutch in the wheel and press center. Tighten bolts and 25N? The torque of m is turning against the Angle. The repair of the clutch a Liner: replace the paper seal gasket and replace the o-ring. Adjusting gasket: adjust the gasket with a micrometer, and can accurately measure the thickness of the needed gasket. Check to see if there is any damage on the edge of the gasket, and can only be loaded in good condition. Baffle, lock ring: adjusting the baffle and locking ring not to be overstretched, must be placed completely in the slot. Bolt, nut, fixed cover and cover bolts and nuts shall be cross tighten and loosen (especially vulnerable parts), and shall be in accordance with the provisions of the torque to tighten bolts and nuts. Bearing: a marked side roller bearing (wall thickness) is applied to the mounting tool, and a layer of lubricating oil is applied between the shaft and the bearing. A