矫正通用工艺(国外英文资料).doc

矫正通用工艺(国外英文资料) Steel construction work documents File number: WHI/JS - TG - 008 Version number/revision number: A / 1 Orthopedic process Controlled state: controlled Issuing serial number: write audit approval Release date: 2006.3.1 implementation date: 2006.3.1 Technical writing Orders to record Subject matter and application scope 2 Create a base 2 The method of correction is classified 2 4 flame correction procedure 2 The general requirements for steel correction are 2 Methods and requirements for all kinds of steel component correction 6.1 plate deformation correction 3 Correction 3 of section 6.2 The correction of 6.3 and H shapes is 5 The correction of 6.4 box column is 5 The cross column of 6.5 is corrected (bent) 6 The cross of 6.6 is adjusted for 6 7, corrective quality check 7 Subject matter and scope of application Main content: general technical requirements for steel and section correction. Scope of application: applicable to the corrective of finished products of plates, profiles and components. 2. The compilation basis Structural steel structure welding technology discipline jgj81-2002 Jgj99-98, the technical regulations on structural steel structure of high-rise civil buildings Classification of corrective methods The processing procedure is divided into raw material correction, molding correction and post-soldering correction. According to the correction, the sources of external forces are mechanical correction, flame correction, manual correction, fire and mechanical combination correction. Fire correction procedure procedure The correctional personnel shall be trained, qualified for the examination, and shall hold the certificate of duty in order to operate. Preparation before correction, check for oxygen, propane, tools and equipment, select suitable welding moment and welding mouth. To understand the mechanical properties, structural characteristics, rigidity, technical conditions and assembly relationships of the material and materials of corre