电机驱动解决课件.pptxVIP

Update the working instruction X1 X4 X3 X2 The step to judge the inverter: 1.If the inverter report the fault code, please the look into the SEW fault message handbook. 2.If find some place short circuit. Take out the X1 to judge the power supply side. Take out the X4 X3 X2 to judge the inverter side and the brake module and brake resister Measure the motor Measure the inverter 2 故障说明 3 故障说明 4 故障说明 5 故障说明 6 故障说明 How to measure the inverter Use the multimeter red pen connect the X4 7 port (u-) Use the multimeter Black pen connect the X1 L1/L2/L3 respectively Measure the voltage judge rectifier bridge the voltage should be the same Use the multimeter red pen connect the X4 7 port (u-) Use the multimeter Black pen connect theX2 U/V/W respectively Measure the voltage judge inverter the voltage should be the same How to measure the motor First step: Use the multimeter to measure the Three-phase resistor , The value should be the same. How to measure the motor Second step: Open the cover Use the multimeter measure the insulation(from 1 to PE and from 2 to PE and from 3 to PE) Use the multimeter measure the Three-phase resistor (from1 to 6 and from2 to 3 and from 4 to 5), The value should be the same. Take out the cable between the inverter and the motor and use the digital multimeter to measure the resistor. Decide to change SEW Inverter Turn off the Maintenance Switch And Remove the old SEW Inverter and install the new one Take off the memory card from the old inverter insert to the new inverter Move the inverter to the reference position on zenon Reference the position Test the other position Finish If the motor can move in normal Y Y Check the profinet communicate status Reset the factory setting in P802 And download backup Move to mechanical zero position And Set SEW motor reference zero position N Update the process Y Assign the device name and IP address N Check the referenc