斜角切削过程的三维热_弹塑性有限元分析.pdfVIP

15 5 计算机集成制造系统 Vol. 15 No.5 2 0 0 9 5 Computer Integrated Manufacturing Systems May 2 0 0 9 : 1006 5911( 2009) 05 1010 06 , , ( , 310027) : , ABAQUS/ Explicit , , , :; ; ; :TH 123.2 :A Threedimensional thermoelasticplastic coupled finite element analysis for oblique cutting processes BA I Wanj in, W U H ongbing , D ON G H uiyue ( School of Mechanical and Energy Engineering, Zhejiang University, Hangzhou 310027, China) Abstract: Based on large deformation theory and virtual work principles, a t hreedimensional ( 3D) thermoelast ic plast ic coupled Finite Element Analysis ( FEA) model was constructed. Several key FEA t echniques w ere analyzed and implemented t o improve the accuracy and efficiency of the FEA simulat ion. An oblique cutting case was simula ted using t he 3D FEA model. The simulation results were presented and analyzed, including the chips geometric shape and its evolution processes, the st ress, st rain, cutting forces, and temperature dist ributions in the w orkpiece, tool and chip, as well as the residual stresses dist ributions on the machined surf ace. The 3D thermoelast icplast ic FEA model w as proved to be effective by com paring some results of the simulation cases. This FEA model could be used t o optimize the processing parameters and rational selection of the geometric parameters of cutting tools. Key words:oblique cutting; finite element analysis; thermoelasticplastic; cutting tools 0 , , ,