02 TGJ-QC-0002-Rev.0_超声波检验程序.pdfVIP

OFFSHORE OIL ENGINEERING CO.,LTD. DOC-202 TGJ-QC-0002 CONTENT 目 录 1.0 SCOPE 范围 3 2.0 REFERENCE STANDARD 参考标准 3 3.0 PERSONNEL QUALIFICATION 人员资质 3 4.0 EXTENT OF NDT NDT范围3 5.0 TIMING OF NDT NDT检验时间4 6.0 UT TESTING PROCEDURE 超声波检验程序 4 7.0 REPORT FORM 报告格式 15 ULTRASONIC INSPECTION PROCEDURE PAGE 2 OF 16 OFFSHORE OIL ENGINEERING CO.,LTD. DOC-202 TGJ-QC-0002 1.0 SCOPE 范围 This procedure covers the methods, techniques and acceptance criteria for structural Ultrasonic Inspection of 202 STINGER PROJECT. 本检验程序包含了 202 托管架项目结构超声波检验的检验方法、检验工艺和验收标准。 2.0 REFERENCE STANDARD 参考标准 • Recommended Practice for Ultrasonic and Magnetic Examination of Offshore Structural Fabrication and Guidelines for Qualification of Technicians. API RP 2X-2004. 海上结构件超声检测和磁粉检测推荐作法及无损检测人员资格指南， 2004 版。 3.0 PERSONNEL QUALIFICATION 人员资质 Personnel performing the NDT testing shall be qualified and certified to NDT Level II in accordance with the requirements of SNT-TC-1A recommended practice or equivalent qualifications approved by OWNER. 所有从事无损检验工作的人员均应按照 SNT-TC-1A 推荐作法或等同标准取得 II 级资质 证书，或同等资质并由经过业主的批准。 4.0 EXTENT OF NDT NDT 范围 Extent of NDT to be carried out as weld NDT drawing and Appendix 1. NDT 范围应按照焊缝 NDT 图纸和附录 1 要求进行。 Ultrasonic Testing applies when material thickness is more than 12.7mm. 超声检验适用于材料厚度大于 12.7 毫米的壁厚。 Areas which have been strained in the through thickness direction by welding will be ultrasonically tested for lamellar tearing. 应当对在焊接时承受厚度方向应力的部位，进行超声检验，确保没有层状撕裂。 ULTRASONIC INSPECTION PROCEDUR