PCB设计的基础绳尺请求)（国外英文资料）.doc

PCB设计的基本原则要求)（国外英文资料） Analog signal and digital signal back into the ground, because of fast digital signal changes, thus in the digital noise caused by the earth will be very big, and the analog signal is need to refer to a clean work. If the simulation is mixed with Numbers, the noise affects the analog signal. In general, the simulated ground and the Numbers are processed separately, then connected by a fine line, or by single points. The general idea is to try to block the noise from the digital ground to the simulated ground. , of course, this also is not very strict request analog ground and digital ground must be separated, if analog part near the digital earth is very clean word can be together. The basic principle of PCB design The size and size of the PCB board In PCB design, determination of the size of the plate is the primary link, no matter what kind of electronic products, it is the size of the PCB is limited by the shell or the size of the case, not beyond the scope of the shell internal reserve it. The connection of PCB and external components The PCB and external components are typically connected through a plastic wire or a metal wire. But sometimes it is also designed to be a socket, which means installing a plug-in printed circuit board in the device to allow for the placement of the socket. For larger components installed on printed circuit boards, attach the metal attachment to improve the vibration resistance and shock resistance. Design principles of PCB layout First, we need to know the specification, size and area of the selected component and various outlets. Of the various components of the location arrangement is reasonable and careful consideration, mainly from the Angle of the electromagnetic compatibility, anti-jamming, the short line, cross, less power, path and decoupling, etc into consideration. Parts location set, is the online components, in accordance with the relevant circuit diagram connection pins, there are many methods to