《采油工程(含课程设计)》第三次在线功课（国外英文资料）.doc

《采油工程(含课程设计)》第三次在线作业（国外英文资料） The filling procedure of the first injector is the drainage, washing, test, pretreatment and normal water injection Your answer: wrong Topic score: 0.5 Score: 0.5 Note: drainage, washing well, pretreatment, trial injection, normal waterflood The water injectivity index is the daily water injection rate under the differential pressure of the unit Your answer: correct Topic score: 0.5 Score: 0.5 Note: corresponding to the oil production index In the case of water absorption section, the distribution of injection quantity on the vertical segment of an open layer is given under certain injection pressure Your answer: wrong Topic score: 0.5 Score: 0.5 Note: all injection distribution of open layer segments The principle of fracturing and injection is to reduce the flow resistance of fluid in the stratum near the bottom of the well Your answer: correct Topic score: 0.5 Score: 0.5 Note: increased permeability The fracturing pressure of oil layer 5 is not very different from the extension pressure Your answer: wrong Topic score: 0.5 Score: 0.5 Note: the burst pressure is much higher than the extension pressure A horizontal fracture occurs when the weekly stress on the wall of a well wall reaches the strength of the tensile strength of the rock in the well wall Your answer: wrong Topic score: 0.5 Score: 0.5 Note: vertical cracks are produced Problem 7 usually creates a vertical crack when the pressure gradient of the rupture is greater than 23 Your answer: wrong Topic score: 0.5 Score: 0.5 Note: horizontal cracks The flow capacity of a sand crack is the ratio of the permeability to the width of the crack Your answer: wrong Topic score: 0.5 Score: 0.5 Remark: the product of Problem 9. The acid solution for acid solution is treated with hydrochloric acid Your answer: wrong Topic score: 0.5 Score: 0.5 Note: hydrofluoric acid The main component of the soil acid is hydrofluoric acid Your answer: wrong Topic score: 0.5 Score: 0.5 Note: combining with