塔式起重机(塔吊)是如何加高的？（国外英文资料）.doc

塔式起重机(塔吊)是怎样加高的？（国外英文资料） After each addition, the main string of the tower and the lower support must have a standard joint bolt connection. If the addition is no longer, the eight high-strength bolts between the lower and the standard sections must be fully connected to ensure the bolt pretension is required. ; (3) the step on the standard section must be correct with the existing standard section. (4) to ensure the safety of the pin shaft at the end of the shaft. (5) the whole process of lifting the whole process requires a special person to look at the wheel and see if there is any derailment and derailment. Disassembly standard section: The order of disassembly of tower crane is the reverse process of installation. That is: the first to be opened first, the first of the first installs. For tower crane is in commonly removal engineering basic strict working hours, some still remove after idle for a long time, equipment technical status and intact degree are likely to exist some problems, so on the preparing work before dismantling tower and tower process should be attached great importance to. On the basis of serious examination and preparation, it is only possible to make the demolition tower work after the concrete conditions of the scene. The removal of the tower should note the following points: Check carefully before (1) down the tower of the main stress components are in good condition, welding parts is normal, the bolt fastening part vice is excellent in good condition, whether the pin shaft, baffle is complete in good condition. (2) carefully check whether the electrical system is normal, sound and reliable. (3) to check whether the operation of various institutions, especially the hydraulic top lifting mechanism, is normal and its technical state is reliable. (4) turn the heavy arm back to the standard section to introduce the window, and use the device such as the rotary limiter to reliably locate. (5) to be removed and the top section of standard sect