简单热传导的例子.pdfVIP

University of Alberta ANSYS Tutorials - www.mece.ualberta.ca/tutorials/ansys/IT/Conduction/Conduction Simple Conduction Example Introduction This tutorial was created using ANSYS 7.0 to solve a simple conduction problem. The Simple Conduction Example is constrained as shown in the following figure. Thermal conductivity (k) of the material is 10 W/m*C and the block is assumed to be infinitely long. Preprocessing: Defining the Problem 1. Give example a Title 2. Create geometry Preprocessor Modeling Create Areas Rectangle By 2 Corners X=0, Y=0, Width=1, Height=1 BLC4,0,0,1,1 3. Define the Type of Element Preprocessor Element Type Add/Edit/Delete... click Add Select Thermal Solid, Quad 4Node 55 ET,1,PLANE55 Copyright © 2001 University of Alberta University of Alberta ANSYS Tutorials - www.mece.ualberta.ca/tutorials/ansys/IT/Conduction/Conduction For this example, we will use PLANE55 (Thermal Solid, Quad 4node 55). This element has 4 nodes and a single DOF (temperature) at each node. PLANE55 can only be used for 2 dimensional steady-state or transient thermal analysis. 4. Element Material Properties Preprocessor Material Props Material Models Thermal Conductivity Isotropic KXX = 10 (Thermal conductivity) MP,KXX,1,10 5. Mesh Size Preprocessor Meshing Size Cntrls ManualSize Areas All Areas 0.05 AESIZE,ALL,0.05 6. Mesh Preprocessor Meshing Mesh Areas Free Pick All AMESH,ALL Solution Phase: Assigning Loads and Solving 1. Define Analysis Type Solution Analysis Type New Analysis Steady-State ANTYPE,0 2. Apply Constraints For thermal problems, constraints can be in the form of Temperature, Heat Flow, Convection, Heat Flux, Heat Generation, or Radi