【2017年整理】f18加装倒车影像.pptVIP

全新BMW5系加装倒车影像 准备工作 执行简易测试 断开蓄电池负极 首先必须拆下以下部件 尾门饰件 尾门促动按钮 行李箱饰件 行李箱左侧轮拱饰件 后部封闭面板饰件 行李箱右侧轮拱饰件 松开右侧后部配电盒 Evaluation only. Created with Aspose.Slides for .NET 3.5 Client Profile 5.2.0.0. Copyright 2004-2011 Aspose Pty Ltd. 加装步骤（安装摄像头及控制单元） 拆下后行李箱饰板及后行李箱开关 组装套件内提供的开关及摄像头 Evaluation only. Created with Aspose.Slides for .NET 3.5 Client Profile 5.2.0.0. Copyright 2004-2011 Aspose Pty Ltd. 加装步骤 安装后的摄像头位置 Evaluation only. Created with Aspose.Slides for .NET 3.5 Client Profile 5.2.0.0. Copyright 2004-2011 Aspose Pty Ltd. 加装步骤 按照图示位置布设摄像头电缆 将摄像头电缆B经由左侧尾门铰链布设到行李箱内，并注意用电缆扎带K以及带卡扣H的电缆扎带进行固定。 Evaluation only. Created with Aspose.Slides for .NET 3.5 Client Profile 5.2.0.0. Copyright 2004-2011 Aspose Pty Ltd. 加装步骤 注意摄像头电缆B的布线。 当开启或关闭后备箱时，电缆不应扭结或拉伸。 用带夹子H的电缆扎带将摄像头电缆B固定到尾门铰链（1）和侧围（2）上。 Evaluation only. Created with Aspose.Slides for .NET 3.5 Client Profile 5.2.0.0. Copyright 2004-2011 Aspose Pty Ltd. 加装步骤 安装环视摄像机模块支架 注：如果已在车中安装了支架，则不再需要。 将控制单元与之家安装到行李箱中并使用螺栓固定好 Evaluation only. Created with Aspose.Slides for .NET 3.5 Client Profile 5.2.0.0. Copyright 2004-2011 Aspose Pty Ltd. 加装步骤安装并连接改装电缆 布设RGB、K-CAN及模块供电线缆 Evaluation only. Created with Aspose.Slides for .NET 3.5 Client Profile 5.2.0.0. Copyright 2004-2011 Aspose Pty Ltd. 加装步骤 布线准备工作 拆下后排座椅靠背 驾驶员后部门槛石板 B柱饰板 驾驶员侧门槛饰板 前机盖拉手及侧面饰板 驾驶员侧脚步空间饰板 前乘客侧桃木饰板 空调面板 CIC车载通信计算机 Evaluation only. Created with Aspose.Slides for .NET 3.5 Client Profile 5.2.0.0. Copyright 2004-2011 Aspose Pty Ltd. 加装步骤 将线束从行李箱左后侧面的线束支架内穿入 将加装线束与原车线束捆绑在一起 Evaluation only. Created with Aspose.Slides for .NET 3.5 Client Profile 5.2.0.0. Copyright 2004-2011 Aspose Pty Ltd. 加装步骤 将线束从后部座椅经B柱延伸至左侧A柱下方 后部座椅 加装的线束 Evaluation only. Created with Aspose.Slides for .NET 3.5 Client Profile 5.2.0.0. Copyright 2004-2011 Aspose Pty Ltd. 加装步骤 将电线束经转向柱上方与仪表板内的车身线束固定好并与CIC供电线束捆绑在一起 将RGB导线连接至CIC插头内 - RT电缆，至针脚18 - WS电缆，至针脚28 屏蔽，至针脚27 用小连接器连接K-CAN总线 - OR/GN电缆，至针脚11的同色电缆 - GN电缆，至针脚9的同色电缆 Evaluation only. Created with Aspose.Slides for .NET 3.5 Client Profi