改变穿筘方法生产条织物的技术措施_赵卫国.pdfVIP

36 10 ∀ 60! # 636# Co tton Text iel T echno logy 2008 10 改变穿筘方法生产条织物的技术措施 赵卫国 陶 文 黄彦萍 张元红 () : 探讨用花筘和空筘穿法生产亮丝条织物和竖条布的生产工 技术要点针对亮丝或金银丝遇高 温溶解而不能经浆纱的特点, 在浆纱机机头和复分绞棒之间安装一 个亮丝筒子架; 在穿综工序和穿筘工序要严 格按照照图穿法穿综, 每穿完一组小循环组织后就验筘, 筘号的选择也要比同品种正常穿法要大; 在织造工序, 边组织紧度要与地组织紧度相近, 以避免紧边断边采取以上技术措施, 才能保证下机一等品达 95% 以上, 织 疵 2. 3% 以下, 织机效率 93. 8% 以上 : 喷气织机; 条格织物; 筒子架; 穿综方法; 花筘穿法; 空筘穿法; 边组织; 紧度 : TS 106. 5 : B : 200 8) 1000600 3 TechnologyM easures of Producing Checked Fabric by Changing ReedinM ethod Zhao We iguo Tao W en H uang Yanp ing Zhang Yuanhong ( Shaanx iT anghua 4 Cotton T ex ti e Co. , L td. ) Abstract T echno ogy and production key po ints o f produc ing shiner checked fabr ic and vertica strip fabr ic by empty reeding and fancy reed ing w ere discu ssed. Sh iner f i am ent cree stand w as insta ed be wt een s izing m ach ine head and reease rod becau se sh iner fi ament w ou d be d isso ved w h i e be sized in h igh tem perature. A ccording to oom ing drafting draw ingin shou d be carried out strict y in reedin and hedd e draft processing. R eed inspection shou d be done once f in ishing a itt e w eave repeat. R eed counts shou d be chosen a rger than tha t o f norma draw ingin m ethod in sam e produc t. In w eav ing process, se vage w eave tigh tness shou d be c ose to basic w eave tightness to avo id tigh t se vag e or broken se vage. A fter adopting the above m easures f irst grade pe rcentag e before c oth repair ing cou d reach above 95% , w eav ing defect is be ow 2. 3% , oom eff ic iency cou d reach above 93. 8% . K eywords A irje t L oom, Checked F abr ic, Cree Stand, D ra