2811限速.docVIP

最新热心网友帮我写了个程序 首先单独控制一台电脑的网速 10.0.5.254 如ip10.0.5.254 进行限速为30K # 第一步定义acl acl nu 3333 rule permit ip sou 10.0.5.254 0.0.0.0 des any 第二步定义策略 traffic classifier celue1 operator and if-match acl 3333 traffic behavior celue2 car cir 30000 cbs 15000 ebs 4000 green pass red discard 第三步定义qos策略 qos policy qoscelue classifier celue1 behavior celue2 第四步接口应用 interface e0/1 qos apply policy qoscelue inbound qos apply policy qoscelue outbound 实验后可以成功 但后来我想大范围使用这个策略 10.0.02---10.0.5.245这个范围全部限制 就是改用第一个策略 修改成rule per ip sou 10.0.5.0 0.0.0.3 然后就是没有匹配住 全是0 不知道怎么回事 有知道的吗 热心网友写的作用在AR 28-31 路由上 限速配置 1. 定义acl Quidway sy [Quidway] [Quidway]acl number 2100 rule 0 deny source 10.0.5.241 0 rule 1 deny source 10.0.5.242 0 rule 2 deny source 10.0.5.243 0 rule 3 deny source 10.0.5.244 0 rule 4 deny source 10.0.5.245 0 rule 5 deny source 10.0.5.246 0 rule 6 deny source 10.0.5.247 0 rule 7 deny source 10.0.5.248 0 rule 8 deny source 10.0.5.249 0 rule 9 deny source 10.0.5.250 0 rule 10 deny source 10.0.5.251 0 rule 11 deny source 10.0.5.252 0 rule 12 deny source 10.0.5.253 0 rule 13 deny source 10.0.5.254 0 rule 15 deny source 10.0.0.1 0 rule 20 permit source 10.0.0.0 0.255.255.255 [Quidway-acl-basic-2100] quit [Quidway] 2. 将acl2100 嵌入到class中 [Quidway] [Quidway]traffic classifier xiansu operator and [Quidway-classifier-xiansu]if-match acl 2100 [Quidway-classifier-xiansu] quit [Quidway] 3. 定义一个流量策略级 [Quidway] [Quidway]traffic behavior xiansu [Quidway-behavior-xiansu]car cir 245760 cbs 15000 ebs 4000 green pass red discard [Quidway-behavior-xiansu]quit [Quidway] 4. 定义qos策略，并将上两个流量策略嵌入进入 [Quidway]qos policy xiansu [Quidway-qospolicy-xiansu] classifier xiansu behavior xiansu [Quidway-qospolicy-xiansu] quit [Quidway] 5. 将qos策略应用到与电信互联接口 [Quidway] [Quidway]int e0/0 [Quidway-Ethernet0/0]