BISS0001的道理与应用(国外英语资料).doc

BISS0001的原理与使用 Heat release sensor handles the principle and use of chip BISS0001 One, chip characteristics: * mixed-signal CMOS manufacturing * * have independent high input impedance of the operational amplifier * internal bidirectional image detectors can effectively suppress interference * with * and blocking time delay timer timer DIP encapsulation using 16 feet Second, foot function: Three, the footnote: pin The name of the The I/O Functional specifications one a. i. Repeatable triggers and non-repeatable trigger options. Allow repeated triggers when A is 1; Instead, the trigger should not be repeated 2 VO O Control the output of the signal. This is triggered by the rise of the VS, which makes the Vo output from a low level jump to a higher one, which is normally seen as an effective trigger. Vo maintains a low level state while the output delay time of Tx and no VS. 3 RR1 -- Output delay time Tx 4 RC1 -- Output delay time Tx 5 RC2 -- Trigger the control end of the blocking time Ti 6 RR2 -- Trigger the control end of the blocking time Ti 7 VSS -- The working power supply is negative 8 Type VRF (variable refrigerant flowrate) i. Reference voltage and reset input. Usually VDD, when the 0 is received, the timer is reset 9 VC i. Trigger the bar. When the Vc VR is not triggered; When the Vc VR is allowed to trigger (VR is approximately 0.2 VDD) 10 The IB -- Operation amplifier offset current setting end 11 VDD -- The working power supply is at the end 12 2 the out O The output of the second stage operation amplifier 13 2 the in - i. The inverting input of the second stage operation amplifier 14 1 the in + i. The same phase input of the first stage operation amplifier 15 1 the in - i. The anti-phase input of the first stage operation amplifier 16 1 the out O The output of the first stage operation amplifier Four, the chip USES parameters: Five, introduction to working principles: BIS0001 is composed of operational amplifier, voltage comparator, state controller,