FT-3 线切割控制器详解(国外英语资料).doc

FT-3 线切割控制器详解(国外英语资料) FT-3 line cutting controller detailed Chapter 1 function and technical index I. major functions FT - 3 controller is one of the most advanced WEDM controllers in the groove. Besides the function of the general controller, it has the following features and functions: 1., large memory capacity, once stored up to 801 procedures, can be stored in common procedures for call at any time; the controller uses an efficient Ni - Cd battery, micro power CMOS integrated circuit, Stored procedures can be stored for 5 years off power. 2. high-speed online transfer program, divided into photoelectric input or telegraph head response type input; when using the telegraph head type input, the transmission speed is 4 times faster than the ordinary controller It has photoelectric coupling, which ensures the correctness of the data and the reliability of the controller. 3. can process input program, including manual input, tape input, computer input online. 4. extremely high speed program return zero check, can forward or reverse tell the check procedure to return zero error, check 100 procedures only a few seconds. 5., you can query, delete, modify, insert any program, processing can display arbitrary X, Y, J, GZ, processing program number, frequency shift, cutting efficiency and other data. 6. can break the wire back to the origin and reverse cutting. 7. symmetrical, translation, rotation, increasing cycle rotation (input gear program, automatic completion of the whole tooth processing), clear angle (can be eliminated due to mechanical or high-frequency sampling adjustment inappropriate And other functions caused by sharp corners and non sharp points. 8. short circuit automatic rollback. Power cut protection cutting point. 9. can automatically find the center, automatically rely on the end surface. Two. Technical indicators 1., dimensions: 380mm (long), *310mm (width) *170mm (height) 2. weight: 4Kg 3. power supply voltage: 220V (180V~240V) 4. maximum power consum