吉大《工程力学》在线作业一(国外英语资料).docVIP

吉大《工程力学》在线作业一(国外英语资料) Kyrgyzstan Engineering Mechanics online homework Total score: 100 test time: - Radio examination Judgment question Radio examination questions (10 questions, 40 points) 1. the mechanical properties of low carbon steel after cold hardening have the following changes. A. yield stress increases and elastic modulus decreases B. yield stress increases and toughness decreases The C. yield stress remains unchanged and the elastic modulus remains constant The D. yield stress remains unchanged and the toughness remains unchanged Full marks: 4 2. the ability of a component to act under external force is called stability. A. does not break B. does not deform C. keeps the original balance D. stays still Full marks: 4 3. the rectangular section beam is subjected to bending deformation. If the height of the cross section of the beam is doubled, the maximum normal stress in the beam is several times that of the original beam () A. 1/2 times B. 1/4 C. 1/8 times D. is not sure Full marks: 4 4. three rigid plates are joined by (or) three hinges 22 to form a geometric invariant system. A. collinear B. is not collinear C. virtual D. non virtual Full marks: 4 The differential equation of deflection curve of 5. beam is established under () condition. The deformation of A. beam is small deformation B. material obeys Hookes law The C. deflection curve is in the xoy plane D. meets A, B, C at the same time Full marks: 4 The deflection of the 6. beam is (). The displacement of a vertical point along the axis of a beam at any point in the cross section of a A. The linear displacement of the centroid of the B. cross section along the vertical axis of the beam The line displacement of the center of the C. cross section along the beam axis Displacement of centroid of D. cross section Full marks: 4 7., the applicable scope of generalized Hookes law is (). A. brittle material B. plastic material C. any material The D. material is isotropic and in a linear elastic range Full m