地下室底板抗浮措施(国外英语资料).doc

地下室底板抗浮措施(国外英语资料) Anti floating measures for basement floor An outdoor pool fire, 4 meters deep, underground water level 0.5m, in order to solve the problem of anti floating, the pool covering soil, pool or low uplift pile, but the pool of top soil is too thick, how and what better can solve the anti floating Anyway, is to think of ways to increase the weight of Bai, wall panels are thicker ~! If you dont, the flowers will only pile up It is the most direct and effective method to use the top covering of soil to solve the problem of anti floating and to solve the problem of pond water icing In fact, to increase the floor weight is the best choice ~! When calculating the floor plate, increasing the deadweight of the floor does not increase the load on the floor, as buoyancy is offset by ~ Bottom board pick 1~2m, general anti floating can be solved. No more sand on the bottom. In the concrete cold talk, check it out! Mention a standard CECS86-96 These two specifications can be referred to The anti floating design of rectangular pool and clear pond can be carried out, which is more typical The pond is usually covered with roof and covered with soil No cap pond generally use self weight, anti floating, self weight plus counterweight, uplift pile anti float, set one-way valve The main control parameter is the coefficient of safety against floating (specification can be found, generally 1.05) Anti floating calculation: 1. calculated the pool of water buoyancy F, that is, using the buoyancy formula in physics to calculate, groundwater levels generally take outdoor design, ground below 0.5m; 2. calculate the dead weight of tank G; 3., control anti floating: (0.9) G-1.2F should be no less than 0; if Shanghai area, the weight of G sub factor 1; if the nonlocal G coefficient of 0.9. 4., general measures: 1) increase the length of the outer panel, and the contribution of the overlying soil to the G 2) hit the uplift pile First calculate the empty pool (the worst case) than the