106散热器安装施工工艺(国外英文资料).docVIP

106散热器安装施工工艺(国外英文资料) 1 scope The technology standard is suitable for use in grey cast iron of this type, round airfoils, column type and M132 type radiator group and installation, steel flat tube type, plate type, column type and series radiator installation project. Construction preparation 2.1 material requirements: 2.1.1 radiator (cast iron, steel) : the type of radiator, the specification, the pressure must meet the design requirement, and have the factory certificate. The radiator should not have sand eye, concave and convex, partial mouth, crack and upper and lower center distance are not consistent. Wing radiator fins are in good condition. The blade of the steel series shall not be loose, curly and damaged. The steel radiator should look beautiful, the silk buckle is good, the elastic is suitable, the paint is intact, the whole set of furnace film is not warped. 2.1.2 radiator group for parts: silk, furnace wall, furnace wings bushing, threaded flange, elbow, bow bend, short silk, tee, elbow, oil, bolt and nut should comply with the quality requirements, unbiased buckle, square buckle, floss, buckle. The thread is correct, and it is elastic. Asbestos rubber mat is suitable for 1mm thick (no more than 1.5 mm thick), and meet the pressure requirement. 2.1.3 other materials, round steel, brace mat, hook, fixed card, expansion bolts, steel pipe, cold air door, antirust paint, oil, ink, twine and selection of cement should comply with the quality and specification requirements. 2.2 main tools: Machine tools: bench drill, hand electric drill, percussion drill, electric test pump, sandwheel saw and wire machine. 2.2.2 tools: cast iron radiator group on shelves, and the key to silk, pressure case, tongs, iron brush, saw blade, hammer, wrench, sets of wire plate, homemade wrench, chisel, hacksaw, tap, stewed pig, welding tools, radiator, manual hydraulic test pump truck, etc. Measuring device: horizontal ruler, steel ruler, line drop, pressure gauge. 2.3 working cond