中国建筑施工网论坛--旋扩珠盘桩旋工方案(国外英文资料).docVIP

中国建筑施工网论坛--旋扩珠盘桩旋工方案(国外英文资料) Rotary beading scheme Rotary beading scheme Construction sequence The orientation of the construction preparation, pay-off, pile hole pay-off, spiral drill hole formation, pile hole self-checking, spin up into dishes, clean up the pile hole, inspecting and self-checking, foundation pile hole trough, concealment acceptance, put steel reinforcement cage, concrete pouring and curing concrete, test pile, the completion of acceptance. (2) construction methods 1, construction preparation and positioning line: inspect the site of the construction and make the layout. Coordinate with the relevant units, complete the three-way work, carry out the location of the building, and make a record of checking the verification visa. To contact building materials and make materials, test and match the pre-trial work. The project owners shall arrange for the removal of the original hardened ground level. Spiral holes into holes (1) to carry out the pile-hole measuring and discharge line, and the inspection is correct. (2) the foramen shall control the size of the hole by the design and the hole depth, and the screw will be drilled into the hole and then check it in time. (3) the relevant provisions of the displacement of the pile hole must not exceed: pile foundation center line of allowable deviation of 70 mm, verticality deviation 1%, allowed the pile hole diameter deviation is allowed to 20 mm, the pile hole depth meet the design requirements. (4) the orifice is covered by a plate so as not to fall into the hole. 3, bead forming (1) based on design drawings, the hole wall elevation point locus of control, make the broaching machine into the pile hole size meets the design requirements of drawings to the first position, and make the corresponding tags in this position. (2) the position of the first set of position is taken, the position of the expanding machine to the two disk is raised, which is to satisfy the design requirement of the spacing of the dis