光驱不读盘(国外英文资料).docVIP

光驱不读盘(国外英文资料) If a disk drive dont read, we first in an original discs with electricity and added after check panel lights flashing, is there a da, da, da the sound, if you have, so we can conclude that is laser sensor with main bearing is broken. Because when we put in a CD, bald first need through the sensor location, if the sensor is broken, they constantly seek baldheaded, resulting in da, da, da the sound. If the above situation, as long as we open the light shell, LG optical drive, for example, beside the main bearing dents where there is a pencil lead 3 mm thick long thin column, it should be with a light head and the relative position of the white plastic headend. If not, you can use glue or other objects to carefully extend the front end of the white plastic sheet, and the problem will be solved. If the panel lights and no sound, then open the enclosure after power up into the CD, observation of main motor working condition, no action, if the dominant motor shall first check the main motor power supply is normal, whether the drive belt skid, fault. The switch is on and off, because if the switch is not in place, the main motor will not be able to start the signal. To determine whether the optical drive is a circuit fault, or if the laser has a fault, it can be put into a good quality plate. The laser transmitting tube is bright (red), the optical drive panel indicates the light is bright; The laser head frame has a reset action (back to the main shaft motor); The laser head is retrieved by the inner circle of the disc and then goes back to the main shaft motor. The laser head focusing on the lens focuses the search three times, and the main shaft motor accelerates the search for the disc three times. If the above action happens, laser tube, a spindle motor stalling, the drive control circuit and servo circuit is normal, it is possible that the laser component failure. Otherwise, check that the optical drive control circuit and the servo circuit are normal.