南方灵锐S82_RTK简易操作说明(国外英文资料).docVIP

南方灵锐S82_RTK简易操作说明(国外英文资料) Southern spirit S82 RTK simple operation specification (2008-10-1123:337) : GPS RTK S82 yupei Emmanuel miscellaneous talk classification: GPS The RTK consists of two parts: the base station and the moving part. The procedure is to start the base station and then move the station. One. The base station section The frame is on a given point, and the balance is flat (for example, the frame is roughly flat on the unknown point). Connect the power cord and transmit antenna cable. Note that the power supply is positive and negative (red is black and negative). 3. Open the radio host and host began to automatic initialization and search satellite, when satellite and satellite quality reach the requirement (about 1 minute), on a host of DL lights began to flash 2 5 second, at the same time the TX lights on the station began to flash once every second. This indicates that the base station difference signal starts to launch, and the entire base station begins to work normally. Note: in order to let the host can search to more quantity and high quality of satellites, the base station around the persons to be in commonly vision, avoid the globe have large buildings within the 15 degree Angle; In order for the base station difference signal to propagate further, the base station should be selected in higher ground. Two. The mobile station section Connect the station host to the carbon fiber to the middle pole, and attach the receiving antenna to the top of the host machine, while holding the handbook in the right position of the middle pole. 2. Open the host, the host began to automatic initialization and search satellite, when after reaching certain conditions, the DL indicator light on the host began to flash 1 1 second (must be on the premise of benchmark was normal differential signal of fire), showed that benchmark station differential signal has been received. Open the manual and launch the project star software. Engineering star general in hand b