双轮铣成槽机技巧初探(国外英文资料).docVIP

双轮铣成槽机技术初探(国外英文资料) The ground is used in combination with an impact drill or blasting. 2) it is not flexible to be restricted by the equipment, especially in phase 2 slot. 3) it is sensitive to the iron in the strata or the steel bar in the original formation. 4) equipment maintenance is complex and expensive. The equipment has a higher self-importance and more traditional equipment. The construction progress and economic comparison of 2.3 double-wheel milling and traditional construction techniques Double milling equipment construction progress with traditional scratch slot machine and punching machine in the soil, sand and other weak formation is not very obvious advantages, is about to grasp of the slot machine 2 ~ 3 times, grasp the slot machine in pore forming efficiency about 10 m3 / h, double milling groove speed the efficiency in such a formation in 20 m3 / h ~ 30 m3 / h. Once in the rock section, double milling will show its advantage, choose appropriate tools, rock in the weathering of rock (mpa) under 60, the construction efficiency can reach 10 m3 / h, in the breeze strata (mpa 60 ~ 120 mpa) can reach 1 m3 / h ~ 2 m3 / h. In the formation of grasp basic cannot use machine, punching pile machine must be used to complete, punching speed in weathered rock strata in about every 4 m to 6 m, affecting the efficiency in 0.3 m3 ~ 0.5 m3, if in the breeze in the formation drilling is extremely difficult, each affecting penetration can only stay a few centimeters, efficiency is very low. Cost: a comparative analysis on the double milling slot costs according to different stratum, about 1000 yuan/m3 ~ 1500 yuan/m3, it is normal construction technology of 1.5 ~ 2 times, no advantage in weak strata, but in the depth of diaphragm wall, high accuracy, a hard stratum lithology show advantage. The main technical points of a two-wheel milling machine 3.1 double-wheel milling cutter form Double milling into slot milling equipment wheel cutter according to the lithology of