如何延长齿轮油泵寿命(国外英文资料).docVIP

如何延长齿轮油泵寿命(国外英文资料) How to extend the service life of high viscosity gear pump The transport medium is not only a medium for energy transfer, but also a lubricant, seal and heat transfer medium. Gear pumps that deliver high viscosity fluids should be able to produce the most traffic at lower power consumption, less leakage, and greater pressure. The viscosity of the liquid reflects the difficulty of the flow of the medium, and the excess viscosity increases internal friction resistance. Lower output power. Waste energy and produce too much system temperature. When determining to conveying medium, we should strictly follow the provisions of the product manuals on use manufacturers recommend fluid as far as possible, and paying attention to the working temperature range of the system. When it is hoped to be used within a wider range of temperature, the viscosity index of the transport medium should be higher. When the liquid is more viscous, or when the system is working in a cold environment. You have to make sure that the medium is flowing smoothly. Many oils contain waxy properties, which are easy to crystallize at low temperatures, and the delivery medium should be lower than the expected minimum operating temperature. In addition, the need to transport medium must be sealed in the system, gaskets, hoses and other rubber materials have compatibility, if both are incompatible, then you have to determine the transmission medium. Noise problem Rapid changes in fluid flow rate, flow rate, and pressure in fluid delivery systems. The bursting of the bubble and the changing load are all common causes of noise, and the transmission of high viscosity liquid is the main source of system noise. ?? It is reasonable to determine the working speed of the gear pump, so that the rotation of the gear and shaft to avoid the frequency of meshing resonance can prevent the noise from increasing. Because it is easy to resonate when the meshing frequency is close to the natural frequenc