如何设置ansys的单位(国外英文资料).docVIP

如何设置ansys的单位(国外英文资料) How do I set up an ansys unit Abstract: In this paper, using the finite element analysis software engineering problems made some discussion on material performance of unit, through example shows how the various physical quantities of the unit, To make sure the analysis results are correct. Keywords: finite element, material performance, unit Most finite element algorithms do not specify units of physical quantities used, and different problems can be used in different units, as long as they are in one The units of physical quantities in a problem can be unified. However, due to the possible use of various units of physical quantities in actual engineering problems, such as The fruit is only used commonly used unit according to the habit, the unit is unified on the surface, in fact the unit is not unified, thus result in the wrong computation knot Fruit. For example, in structural analysis, the following units are used: length - m; Time - s; Mass - kg; - N. Stress, stress, bullets The magnitude of the sex modulus, and so on - Pa, the unit is uniform. But if you change the pressure units to MPa and keep the rest of the units unchanged, the units are not A; Or, change the unit of length to mm, the pressure unit to MPa, keep the rest of the unit unchanged, and the unit is not unified. by It is evident that we cannot choose the units of physical quantity according to the custom of manual calculation, but must follow certain conditions The principle of. The unit of physical quantity is related to the system of units adopted. All physical quantities can be divided into basic physical quantity and derived physical quantity, in structure and heat calculation The basic physical quantities are: quality, length, time and temperature. There are many types of physical quantities, such as area, volume, velocity, acceleration, Elastic modulus, stress, stress, heat conductivity, heat exchange, heat exchange coefficient, energy, heat, energy, and so on, are ident