如何车螺纹(国外英文资料).docVIP

怎么车螺纹(国外英文资料)Threading the steps and methods: (low speed cutting triangular thread V く 5 m/min) 1, threading the former requirement for artifacts: 1) the thread size: large diameter is equal to the nominal diameter in theory, but according to cooperate with the nut it has lower deviation (-), the deviation of 0; So in the process, according to the requirement of thread level three. The diameter of the thread is 0.1 p. The diameter of the thread is equal to the nominal diameter of 0.1 p2: the end of the thread must be refunded to the end of the thread so that the tool can exit in time. 3) chamfering: before threading due at the beginning of an thread and end chamfering, and the small end of the chamfering く bottom diameter of thread diameter. 4) tooth deep height (cutting depth) : h1 = 0.6 p2, adjust the lathe: first turn the handle to screw, according to the pitch of the artifact or lead to adjust feed box handle as shown in the position. Adjust to the handle position. Drive, write down the dial reading for the knife, and exit the car knife to the right. 4, close half nuts, get out a spiral in workpiece surface, transverse exit the tool, and open the handlebar turning back to the right side, stop the pitch is correct (steel rule). Start cutting, using scale to adjust depth (gradually reducing the depth). Note that in the operation, the tool will be ready for the end of the blade, stop and prepare, then exit the tool quickly, then drive the back car to return the tool holder. Turning depth control, rough turning when t = 0.15 ~ 0.3 mm, fine car t く 0.05 mm. Six, the thread measuring: 1, one-way measurement: 1) the top diameter measurement: the size of the screw top diameter, are generally allowed to have bigger error, external thread top diameter available vernier caliper and micrometer to measure, internal thread diameter available vernier caliper measurement. The measurement of pitch: the measurement of the pitch of the pitch, the diameter of the diameter of the th