微小孔测量(国外英文资料).docVIP

微小孔测量(国外英文资料) With laser drilling method to work out a diameter of 0.2 mm, 0.25 mm and 0.3 mm small hole, application of subdivision technique to directly contact measurement to get the inner surface roughness of the tiny hole processing, and use the reflex microscope directly observed further validation. The measurement results can be used for melting rapid prototyping machine nozzle determine the surface roughness of the tiny hole, also can be used to study spinning machine and inkjet printer and similar small hole as a reference. Keywords: small hole, roughness, laser processing, fused deposition modelling 1 introduction of tiny holes machining has always been a difficulty in mechanical manufacturing, around a lot of research on this problem the researchers. Currently available for processing tiny holes: mechanical processing, laser processing, electro discharge machining, ultrasonic processing, electron beam processing and composite processing, etc. There have been more reports of the diameter of tiny holes in various methods, but less research on the roughness of the small holes in the process. With the development of science and technology and cutting-edge products increasingly motors, integration and miniaturization, tiny hole is more and more widely used in automobile, electronic, optical fiber communication and flow control, and other fields, the application of small hole processing is put forward higher request. Fused deposition rapid prototyping machine nozzle is used, for example, a high precision small hole, not only requires the aperture size accurate, but also for the hole wall is smooth, is advantageous to the melt extrusion and tiny pore fluid resistance accurately control when it is squeezed. This paper can be used for rapid prototyping machine to measure the tiny hole wall roughness of nozzle, the further study of the tiny hole roughness of fused deposition rapid prototyping machine nozzle used in the influence of the quality of work. The results