注塑机工艺调整(国外英文资料).docVIP

注塑机工艺调整(国外英文资料) The ratio control of injection rate has been widely adopted by the manufacturers of injection molding machines. Although the computer controlled injection rate section control system already exists, the advantages of this machine are seldom given due to the limited data. This paper introduces the advantages of multi-speed injection molding in the system, and introduces its use in eliminating the defects of short-shot, trapped gas and shrinkage. The close relationship between the speed of the injection and the quality of the products makes it a key parameter for injection molding. By determining the filling speed of segmentation, the end of the beginning, middle, and implement a set point to the other a smooth transition of the set point, can guarantee the stability of the melt surface velocity to create the desired molecules get asked about the smallest internal stress. We recommend the following speed segmentation principle: 1) the velocity of a fluid surface should be constant. 2) it should be used to prevent the melt from freezing in the process of ejection. 3) the speed of the injection should be taken into account when the speed of the filling in the critical area (such as the flow path) is reduced. 4) the injection rate should ensure that the cavity is filled and stopped immediately to prevent the filling, edge and residual stresses. The basis of the setting speed segment must take into account the geometry of the mould, other flow constraints and unstable factors. The speed setting must have a clear understanding of injection molding process and material knowledge, otherwise, the product quality will be difficult to control. Because the velocity of the melt is difficult to measure directly, it can be calculated by measuring the speed of the screw or the indirect pressure of the cavity. Material properties is very important, because different degradation of polymers may be due to stress, increase the mold temperature can lead to severe oxidatio