焊接电流的选择(国外英文资料).docVIP

焊接电流的选择(国外英文资料) The choice of welding current According to the type of welder, the welding current is suitable: the thickness of the plate, the diameter of the electrode, the choice of welding current is proportional to the thickness of the plate and the diameter of the electrode. I is equal to 35 minus 55 times d is the diameter of the electrode. For example, the diameter of the electrode is 4mm, so the haji current is selected between 140-220a. The welding current is suspended according to the position of the welding method: 140A (weld) 140-160a (vertical docking) 180A (flat butt) If it is full position welding (including flat, horizontal, vertical, and elevation), the welding discharge value should be the total electric current value, which is usually the vertical welding current value. The welding level of the fixed pipe is the only one which is the welding current in the whole position. According to the difference of the welding parameters, the low level is used for the lower layer, the filling layer adopts the higher current value, and the surface layer is relatively small. For example, the welding flat is welded, and the normal open groove adopts multi-layer multi-pass welding, the large stratum adopts 150A current, and the filling layer can be used in 180-200a. The cover layer adopts the current value of 10-15a, which ensures that it is beautiful and has no edges and so on. To select the welding current value according to the type and method of the welding rod: According to the type of welder, base stainless steel. Acid type electrode using current value maximum, but the electrode diameter of 4 mm, flat welding butt joint of filling layer can use 180 a current, but in the use of practice of electrode is the same electrode diameter, 20 a smaller but the welding current is 160 a welding current value. If the A137 stainless steel welder is welded. The welding current is about 20% smaller, or about 140A. Otherwise, the welding will not be the result of the re