立磨-操作(国外英文资料).docVIP

立磨-操作(国外英文资料) 1.1 stabilizing bed Keep the stable bed, which is the foundation of the grinding mill of roller mill, and the key to normal operation. Material thickness can be adjusted by adjusting to highly keep-off circles, suitable thickness and corresponding relation between them with the mill production, commissioning stage should be the first to find out. The thickness of the material is too thick and the material is too thin to cause the vibration. If the roll is pressed up, the powder will be thin and the layers will be thin. The roll pressure is decreased, the mill material is thicker, the material is more, the material layer thickens. The inner circle is thickened by increasing the internal circulation, reducing the wind speed, reducing the inner circulation and reducing the material layer. The thickness of the bed should not be less than 40 ~ 50ram after the roller compaction under normal operation. Control powder pressure The grinding pressure is the main factor affecting the production of mill, the efficiency of the mill and the power of the mill. Vertical mill is with the aid of the bed pressure and crushing material, pressure increasing production, but no longer changes after reach a certain threshold, the increase of the pressure increase followed by power, lead to the increase of the unit energy consumption, so the suitable roller to yield and energy consumption for both. The value is determined by the material properties, granularity and feedstock. During trial production to find out a suitable grinding pressure and reasonable wind speed can form good internal circulation, make the material layer on the mill proper, stable, high grinding efficiency. In the production process, when the wind ring area must be, the wind speed is determined by air quantity. The corresponding relationship between the production process ability and the powder grinding effect is guaranteed. 2 \ * o6 v - 1.3 ensures a certain grinding temperature Vertical grinding is a toa