课程设计例题1(国外英文资料).docVIP

课程设计例题1(国外英文资料) Design of belt conveyer system Design a business book (1) design tasks The transmission system of the belt conveyor is designed with two stage gear reducers. (2) raw data The conveyor belt has a valid pull F = 4000 N Speed v = 0.8 m/s (plus or minus 5%) Conveyor belt barrel diameter d = 315 mm The reducer design life is five years (3) working conditions Work in two shifts, at room temperature; No load start, slight vibration of the working load. Voltage is 380/220 V for three-phase ac power. The design of the transmission system The belt conveyor transmission system scheme is shown below. 1 - motor 2 - coupling 3 - two-stage cylindrical gear reducer 4 - shaft 5 - roller 6 - conveyer belt The belt conveyor is driven by an electric motor. Motor one by coupling two power into two levels of the original three cylindrical gear reducer, then through two levels of the original three cylindrical gear reducer and coupling 4 will transmit the power to barrel 5, conveyor belt (6) work. In the transmission system, the gear reducer is simple, but the position of the gear is asymmetric. The level of high-speed gear arrangement, away from the torque input, can make the shaft torque input, can make the shaft on the torque under the action of the torsional deformation of shaft under the action of bending moment and bending deformation partially offset each other, to slow the phenomenon of uneven load distribution along the tooth width. The motors choice (1) the selection of motor capacity The effective power required by the working machine is calculated by the known conditions F = 4000 N Argument = 0.8 m/s Set: Estimate the total efficiency of transmission system Type in the The total efficiency of the transmission system The motor power required by the machine According to the data in the data of series Y motor technology data, the rated power Pm of the motor that satisfies the Pm is greater than the Pr condition is 4kW. The choice of motor speed Working speed of r