P4CPU的发展历程（国外英文资料）.doc

P4CPU的发展历程（国外英文资料） Pentium 4 general introduction: P4, out of the four generations, the first frequency from 1.5 to 2.0, USES is rambus memory, achieved an unprecedented 400 MHZ FSB, due to the poor performance of memory, and expensive, so soon after the shipment, were eliminated. 2 belt is to use 478 interface P4b, williamet core, supports the DDR memory, the highest support ddr333, FSB reached $533, with 3 is the core northwood, front end 533, 800, called P4c, 3.02 at the highest frequency band 4 is the last generation of P4, adopt the Prescott core level 31 line level, support the front, 800-1066 bus, which is finally said P4e and P4ee frequency finally reached 3.8, due to the performance of frequency ratio is very low, so the heat is very big, big power. Become the Intels biggest failure in the market and technology, is this time, AMD started after Intel. Market share from 2% to 2%. P4 period is the biggest technology promotion processor support sse2, sse3 and EMT64 technology. Using the minimum 65 nm technology. And with hyper-threading technology, support dual core simulation. Further enhance the multitasking capability. PD, this time in order to cope with AMD dual-core processor, Intel caocao launched not mature PD, PD and P4e is adopted the same high level of assembly line, the lack of contact between the two kernel, and compared with levels of AMD processors have obvious disadvantage. But as cheap dual-core products, PD is also very good. The biggest advance of the Pd era was that Intel entered the dual core era. PE, you must not have heard of, this is actually a high-end product of PD, PD is actually joined the hyper-threading technology, can see four core, is actually two real core and core. Two virtual performance is very good, in addition to power, no defects. This processor core duo, core 1, only can see on notebooks and apple machine, ordinary desktop PC without, the advantage is low power, on the downside, and PD than, no performance advantage. Core2