数控加工程序（国外英文资料）.doc

数控加工程序（国外英文资料） Example 1.g01 line interpolation instruction programming The FUNAC CNC car is programmed as follows: O9001 N10 x 100 Z10 (define the position of the point of the knife) N20 G00 X16 Z2 M03 (move to the inverted Angle extension cord, Z axis 2mm) N30 G01 U10 W - 5 G98 F120 (3 x 45 ° Angle) N40 Z - 48 (machining cylindrical Φ 26) N50 U34, w-10 (cut the first cone) N60 U20, Z minus 73 N70 X90 (back knife) N80 G00 X100 Z10 (back to the knife point) N90 M05 (main shaft stop) N100 M30 (the main program finishes and reset) Example 2. G02 / G03 arc-interpolation instruction programming, The FUNAC CNC car is programmed as follows: O9002 N10 X40 Z5 (define the position of the point of the knife) N20 M03 S400 (the main shaft revolves at 400r/min) N25 G50 S1000 (rotation of the main shaft of 1000r/min) N30 G96 S80 (the constant linear speed is 80m/min) N40 G00 X0 (the knife to the center, the speed up, until the main shaft to the maximum speed limit) N50 G01 Z0 G98 F60 (work in contact artifacts) N60 G03 U24 W - 24 R15 (processed R15 segment) N70 G02, X26, X26, z-31, R5 (processing R5 circle) N80 G01 Z - 40 (machining cylindrical Φ 26) N90 X40 Z5 (back to the knife point) N100 G97 S300 (cancel the constant line speed function, set the main axis in 300r/min rotation) N110 M30 (main shaft stop, main program end and reset) Example 3 G32 thread cutting instruction programming Format: G32 X (U) __Z (W) __F__ Description: X, Z: for absolute programming, the coordinate of the end of the valid thread in the artifact coordinate system; U, W: for incremental programming, the effective thread ends are relative to the amount of displacement of the starting point of the thread. F: thread guide, which is the value of the tool relative to the part of the workpiece. Using G32 instructions, you can process the cylinder thread, the taper thread and the face thread. The thread lead is 1.5 mm, Each time the weight of the knife (diameter) is respectively 0.8 mm, 0.6 mm, 0.4 mm, 0.16 mm