机械类资料（国外英文资料）.doc

机械类资料（国外英文资料） The introduction and indispensable information of the dry mechanical design The shaft parts This kind of parts do you usually have a shaft and sleeve parts, such as expressed in the view, as long as draw a basic view combined with the appropriate profile and dimension, you can put it express the main shape characteristics and local structure. In order to facilitate the processing, the axis of the axis is usually placed in the horizontal position, the best choice axis is the position of the vertical line. When the size of the part of the axis is marked, its axis is used as the radial dimension reference. This note out as shown in figure 14, Ф Ф 11 (see A - A section) and so on. Thus the requirements of the design and machining process of the benchmark (axial parts on a lathe processing, both ends with a thimble to resist shaft center hole) to unify. The length of the base is often used for important ends, contact surfaces (shaft shoulder) or machining surfaces. The surface roughness shown in this figure is the right shoulder of the Ra6.3, which is selected as the main dimension of the length direction, resulting in the dimensions of 13, 28, 1.5, and 26.5; And then the right-hand side of the right-hand side is the length of the length, and the length of the axis is 96. Plate cover parts This kind of parts is the basic shape of flat disk, typically have end cover, valve cover, gear parts, such as their main structure generally have a solid of revolution, usually with various shapes of flange, uniform circular hole and rib, etc. The local structure. In view selection, generally choose a symmetry plane or sectional view background view of rotary axis, at the same time also need to add the appropriate other view (e.g., left and right views or vertical view) give expression to the appearance of parts and uniform structure. A left view is added as shown in the figure to show the square flange with the rounded corners and the holes of the four squares. When wit