电脑启动挂账解析（国外英文资料）.doc

电脑启动挂账解析（国外英文资料） The second chapter [2: Master (\ Slave) None After the machine is turned on, the Master (\ Slave) None prompt is not able to enter the system. The two IDE devices on the same IDE data line must correctly set the Master from the device, otherwise the Master (\ Slave) None error will appear. To resolve this failure, follow the steps below. (1) check the cable on the two IDE devices (such as a hard disk or optical drive), according to the equipment, set the two devices are mainly equipment and from the device, restart the computer. It is important to note that when setting up the line of the IDE device, it is important to note that the hard disk that the same IDE line is used to start should set up the main device, otherwise the system will not start properly. BIOSROMChechsumerror, Systemhalted After the system started self-examination, there was a BIOSROMChechsumerror, Systemhalted error message that was unable to enter the system. Restart the system again, and the same error message still appears. This prompt information indicates that the BIOS error was detected when the BIOS was checked, and it was probably caused by a failure of the BIOS or an unexpected situation to cause the mainboard BIOS to be corrupted. The problem can be solved by the following method. If a new BIOS is refreshed, the prompt error message appears, indicating that the failure is likely caused by the failure of the refresh BIOS. Normally, refresh after a failed need main board to the manufacturer designated site repair, unless the mainboard has a double BIOS setup, can refresh the fall, with a backup BIOS setup system. 2 if the error is not caused by the refresh BIOS, is probably because the mainboard BIOS for some unexpected damage, in this case, also need the motherboard repair to the manufacturer designated place 3: Harddisk (s) drivefail After the self-examination, the Harddisk (s) drivefail prompt is unable to enter the system normally. The error message is that the hard d